Fitting Guide

 

Step 1 – Choose your Preferred Fitting Kit

“Don’t worry it's really easy.”

We have a range of number plate fitting kits, each one is practical and efficient, the choice is yours!

The Sticky Pad way: 6 x Sticky Pads £3.00

How to do it the sticky pad way.

First of all remove your old plates if you have not already done so. Clean the area where the plate is going to be stuck using a mild detergent or even white spirit for best results, let this evaporate, then stick the pads onto the first plate spacing equally. Pull of the backing tape and stick firmly into place. Take care to get it straight as the pads are very sticky and don’t like to move once on.

Tip: Try to put them on when it is mild and dry as they don’t like cold damp surfaces. Also Try and warm up the area if its cold with a hairdryer for 30–40 seconds. We recommend one set per plate.

The Screw and Cap Kit : £3.00 Consisting of 2 x Yellow Caps, 4 x Black Caps, 2 x White Caps, 4 x Screws

This way is really easy too. Using a 3mm drill bit (HSS/metal bits are recommended), carefully drill acrylic plates from the back surface through to the front, but drill aluminium plates from the front to the back. Ideally, support the plate on a flat surface that can also be drilled into. Do not apply too much pressure to the drill.

Then using the self tapper screws and caps just screw through the bumper plastic close the clip and you’re done.

Tip: If you have already existing number plates with screws this way will be easier for you to fit the plate by using the Screw kit.Just use your existing plate as a template, drill small holes with a 3mm drill bit where the existing holes are and then just screw it straight on your car. Job is done.

Motorcycle Plate Screw kit:  £3.00

These are really easy to use as you just undo the old ones and replace with bright shiny new ones.